You can pretty easily go from a 205/75-14 to a 15 inch tire size like 205/75-15 like with the # AM32395 without clearance issues. This will give you a slightly larger wheel and tire which will have a higher weight capacity. So you might gain a slight increase in ride height if that's something you'd like as well as additional weight capacity. In theory you might see a better ride quality since a larger tire rolls easier over bumps. view full answer...
Just the glass of the Replacement Stainless Steel Top with Glass Cover for Furrion 2-in-1 Range Oven # C-FSRE21SA-SS-003 is not available so you'd need to replace the entire assembly with the # C-FSRE21SA-SS-003. view full answer...
The Tireminder TPMS part # TPMS-TRAILER uses the 433 MHz frequency. If there was a tire pressure loss there would be an alert sent to the monitor. view full answer...
Yes the TireMinder TPMS for Dual Axle Trailers # TPMS-TRAILER that you referenced can be used with rubber valve stems and less than 60 psi as it is rated for up to 70 psi. view full answer...
I do have some options for you to add lights to your awning. If you have a Lippert Solera Awning then there may be a light track on the coach under the awning and in which case you would just use the LED Fabric Light Kit like part # LC674282 and slide it into the track. If you don't have the built-in track or another brand of awning then you can use a simple peel and stick light like the LED Light Strip for Solera RV Awnings part # LC423331 which can be wired to a switch of your choosing. view full answer...
In order to determine the capacity of the rear bumper on any fifth wheel trailer you'll need to reach out to the trailer manufacturer as we don't have this information. That said, it's typically around the 200 lb mark. If you need/want more we do have a way to strengthen the rear bumper using the Mount-n-Lock SafetyStruts Universal RV Bumper Support Brackets part # MO34VR which increases the capacity to 400 lbs. In order to carry cargo and gear on the bumper, I highly recommend the etrailer... view full answer...
I have complete replacement option for you, but unfortunately the face of the control panel for your Lippert Ground Control 3.0 and Travel Trailer RV Leveling System is not available separately and you will need to replace the entire control panel.
The correct replacement control panel is the # LC421484 you were looking at.
I included a video of the # LC421484 for you to take a look at. view full answer...
At the rear of a fifth wheel trailer the ride quality is much rougher than that at the rear of a passenger vehicle due to less sophisticated suspension and a longer distance between the rear axle of the RV and the rear of the vehicle. This puts quite a bit more strain on the bike rack which is why not every rack is rated for this application.
There are also no 1-1/4 inch bike racks that are fifth wheel approved either since this is a lower capacity setup. The closest bike rack solution... view full answer...
First issue you'll have is that the Hollywood Racks bike racks are not rated for use behind fifth wheel campers as the ride quality there is very rough. We can't recommend you continue using your bike rack there as it most likely will fail over time.
The most similar bike rack to what you have that is rated for this type of application is the Swagman Dispatch part # S44FR. This has a 45 lb capacity per bike as well. I attached a review video for this for you to check out as well. This... view full answer...
We aren't able to source the sound bar you are looking for but it looks like it may be discontinued so you'd need to go with a different solution like the Furrion part # FSB2N25MCBL that you referenced. The wiring colors won't be an exact match but they are all individually labeled on the Furrion which would make it a little easier. view full answer...
Great question. So the Dexter E-Z Flex Suspension Kit # K71-652-00 is for use with tandem axles that each have a capacity of up to 6,000 lbs. So total the trailer could have a capacity of up to 12k. view full answer...
Nearly all travel trailers are now prepped for the Furrion systems like the Furrion RV Observation Camera System # FOS43TASF that you referenced. When Furrion was here not long ago they bragged that all RVs that are prepped for a camera are prepped for a Furrion system. The # FOS43TASF is what you would need. Or for a larger 5 inch screen part # FOS05TASF that not only has a larger screen, but also will allow you to add up to 3 additional cameras to give you a total of four. view full answer...
For your cut out the Furrion RV Electric Fireplace with Logs part # FF40SW15ABL would be your best option. This has a cabinet cutout dimension very similar to what you have at 38-5/16" wide x 17-3/4" tall x 6-1/4" deep. There would be a bit of open area above the fireplace which you might be able to come up with a fascia or something similar to take up that area. view full answer...
For the Ultra-Fab Power Twin II Electric Stabilizer with Dual Motors # UF39-941705 to work on your 2013 Prime Time Lacrosse Luxury Lite you will want to confirm that you have the adequate space available on your camper for them. They are a universal fit for frames 48"-80" wide which should fit your Lacrosse. They have an extension of 30" which should also work for you. The main concern is to look for any thing such as sewer plumbing, propane lines, etc that would cause them not to work... view full answer...
For a tandem axle trailer like your Crusader Fifth wheel 28RL we have the Correct Track Tandem Axle lift kit part # RR23QX which will give you a lift of 2-1/4 inches and would help level your trailer like you are wanting. A lift like this is realistically only option you'd have since your springs are mounted above the axle already. view full answer...
A power inverter, or inverter, is a power electronic device or circuitry that changes direct current (DC) to alternating current (AC). So it will turn your battery power (DC) into (AC) like your house. This lets you use appliances and devices that are only capable of using AC power.
The Go Power Heavy-Duty Modified Sine Wave Inverter - 3,000 Watts - 12V # 34280178 is my choice. It has inverter and transfer switch functions so you don't need to manually switch from shore power to inverter.... view full answer...
The Swagman E-Spec Bike Rack for 2 Electric Bikes - 2" Hitches - Frame Mount # S94FR is definitely the bike rack I recommend for you. It is compatible with travel trailers since it is built to withstand the excess bouncing that occurs on the back of a travel trailer or motorhome. This bike rack comes with locks to secure the bikes to the carrier, along with anti-rattle hitch pin to secure the bike rack to the trailer hitch receiver.
The Swagman E-Spec is rated at 70lbs per bike which is... view full answer...
The Progressive Dynamics Lithium 60 amp converter section part # PD4560LICSV only works with lithium batteries. The part # PD4060CSV is version that works with lead acid batteries. There isn't a version that does both styles of battery. The only way to have a setup that could do both would be with an all new panel like the part # PD4060K that can switch between the two. This is also a 60 amp setup. view full answer...
I would be happy to recommend a trailer hitch receiver and 5th wheel rated bike rack for your 2019 Prime Time Crusader 5th Wheel Trailer.
Starting with the hitch I recommend the Curt Adjustable Width Trailer Hitch Receiver # 13703 as it will fit box frames, C-channel frames, or I-beam frames that are 22"-72" wide. The # 13703 is a Class III receiver that has a 350lb maximum tongue weight rating and 3500lb maximum trailer weight rating making it perfect for carrying a bike rack. You will... view full answer...
While the two motors do look pretty similar they actually are different and are not interchangeable. The part # LC352338 is not as long and has a wider base whereas the part # LC138445 is a bit longer. The wiring comes out in two different places too. view full answer...
Go To Results